Front end project Phase 4

Custom turbo intake duct and cold air intake

My intake started off with a dynomax 3" exhaust U-bend. You can get it for around $15usd. It was cut into 3 pieces (2 used) I then painted it black with high temp brake paint. Once again the pipes were cut too long as I did it before the rad was in. They were cut down when installed.

 

I picked up some silicone joints, clamps, and a big K&N from a local store. A vacuum nipple was JB welded on for the "crank" breather line (and one way check valve)

new TID and cold air intake Installed.

 

Relocated overflow bottle to make room for cone filter.

 

 

---Project home---Last Phase---Next Phase---